Kaloud Lotus® I+ - Aluminum Hookah Heat Management Device [HMD]

The Kaloud Lotus® I+ is an aluminum heat management device (HMD) that sits on top of your hookah bowl and controls how much heat reaches the shisha. It replaces foil. You load two large coconut coals inside, set the lid, and the Lotus regulates the burn for you. Sessions run up to 60 minutes without relaunching coals or poking holes.

This is the original. Kaloud introduced the Lotus in 2014 and it defined the category. Everything since has been a copy of it.

Why heat management matters

Shisha does not burn. It vaporizes. Glycerin and flavor compounds release cleanly in a window of roughly 130°C to 220°C (266°F to 428°F). Push past 220°C to 250°C and the tobacco enters pyrolysis. That is where harshness, scorched notes, and the burnt-throat finish come from.

Foil gives you no control over that window. Coals sit directly against it, heat spikes, and the sweet spot lasts a few minutes. The Lotus I+ holds the coals off the shisha and moves heat by convection and radiation instead of direct contact. The vaporization window stays open for the length of the session.

Three heat settings, no tools

• Lid off. Lowest heat. Use it at the start while the bowl is coming up, or to pull back a bowl that has gone hot.
• Lid on, vents open. Medium heat. This is where most sessions live.
• Lid on, vents closed. Maximum heat. For dense-cut tobacco, large bowls, or the back half of a long session.

You adjust by rotating the lid. No lifting coals, no tongs, no guesswork.

Specifications

Figures are approximate and measured by Kaloud.

What it fits

The Lotus I+ is built for standard phunnel and Egyptian-style bowls in the 7 cm range. It pairs natively with the Kaloud Samsaris High Heat Bowl for Lotus I+ and the Samsaris Lapis Ceramic, both of which are dimensioned around it.

Want to protect the finish and handle it hot? The Kaloud Silicone Sleeve three-pack fits all Lotus HMD models.

Lotus I+ or Lotus I+3

Take the I+ if you run standard bowls and one-hour sessions. Take the Lotus I+3 if you run big bowls, long rotations, or group sessions. The I+3 holds four large cubes instead of two, uses a stainless steel base, and stretches to roughly 90 minutes.

Care and handling

Never preheat your Kaloud Lotus I+. Bring the coals up separately on a burner, then transfer them in. Preheating the device itself will damage it and voids the warranty.

Let it cool fully before cleaning. Wipe the interior with a dry cloth or a soft brush. The colored finishes on Azuris, Auris, Vertis, Violis, Cyris, and Niris are not anodized or powder-coated. Kaloud uses a proprietary non-toxic coloring process, so avoid abrasive pads and harsh solvents.

On counterfeits

The Lotus is the most cloned product in hookah. Counterfeits use unspecified alloys, run hot, discolor, and carry no warranty. Kaloud's patent, warranty, and material claims apply only to genuine units.

5StarHookah is a contracted Kaloud dealer. Every Lotus I+ sold here is sourced directly from Kaloud and carries the full Limited Lifetime Warranty. A unit bought outside that chain does not.

Frequently asked questions

Do I still need foil with a Kaloud Lotus?

No. The Lotus I+ replaces foil entirely. Pack the bowl, set the Lotus on top, add lit coals.

How many coals does the Lotus I+ take?

Two large coconut cubes with the lid on. Three smaller cubes also work. Do not overfill, it will not improve the session and it stresses the device.

Can I preheat the Lotus I+ on the burner?

No. Heat the coals separately and transfer them. Direct flame will damage the aluminum and voids the warranty.

How long does a session last with the Lotus I+?

Roughly 60 minutes on average with two coals, depending on tobacco cut, pack density, and airflow.

What is the difference between the Lotus I+ and the Lotus I+3?

The I+3 holds four large cubes instead of two, has a stainless steel base rather than all-aluminum, and runs about 90 minutes versus 60.

Does the color affect performance?

No. All seven colorways are the same aluminum device with the same geometry. The finish is applied with a proprietary non-toxic process, not anodizing or powder coating.

What bowls work with the Lotus I+?

Standard phunnel and Egyptian bowls around 7 cm across. Kaloud's own Samsaris bowls are designed to its dimensions.

Is this a genuine Kaloud Lotus or a copy?

Genuine. 5StarHookah is a contracted Kaloud dealer and sources every unit directly from Kaloud, so the patent, the materials, and the warranty all apply.

Is the Lotus I+ covered by a warranty?

Yes. A Limited Lifetime Warranty plus a 14-day money-back guarantee. Restrictions apply and coverage does not extend to counterfeits.